APC BE350G PDF

Provides early-warning fault analysis on batteries enabling timely preventive maintenance Battery-protected and surge-only outlets Reserves power capacity and run time for connected equipment that require battery back-up while providing surge only protection for less critical equipment Cold-start capable Provides temporary battery power when the utility power is out. Hot-swappable batteries Ensures clean, uninterrupted power to protected equipment while batteries are being replaced Disconnected battery notification Warns when a battery is not available to provide backup power. Dataline Surge Protection Provides protection of connected equipment from power surges on the data lines. Automatic self-test Periodic battery self-test ensures early detection of a battery that needs to be replaced. Audible alarms Provides notification of changing utility power and UPS conditions.

Author:Nabar Basar
Country:Mali
Language:English (Spanish)
Genre:Medical
Published (Last):19 January 2018
Pages:250
PDF File Size:3.42 Mb
ePub File Size:14.83 Mb
ISBN:591-6-59608-853-7
Downloads:77710
Price:Free* [*Free Regsitration Required]
Uploader:Tushura



The Back-UPS is not connected to utility power, there is no utility power available at the wall outlet, or the utility power is experiencing a brownout or over voltage condition. Make sure the power cord is securely connected to the wall outlet, and that there is utility power available at the wall outlet. Where applicable, check that the wall outlet is switched on.

The battery is not connected. Connect the battery. In the event the Back-UPS receives no utility power and the battery is connected, a cold-start can be initiated. Remove all nonessential equipment connected to the outlets. One at a time reconnect equipment to the Back-UPS.

Charge the battery for 24 hours to make sure it is fully charged. If the overload condition still occurs, replace the battery. The Back-UPS battery is completely discharged. Connect the Back-UPS to utility power and allow the battery to recharge for eight hours.

PowerChute software has performed a shutdown due to a power failure. This is normal Back-UPS operation. Connected equipment does not accept the step-approximated sine waveform from the Back-UPS.

The output waveform is intended for computers and peripheral devices. It is not intended for use with motor driven equipment. The Back-UPS may require service. The Back-UPS is operating normally on battery power. At this point the user should save all open files, and shutdown the computer. When utility power is restored the battery will recharge. The Back-UPS battery is near a total discharge state.

The battery is near the end of useful life and should be replaced. Leave the Back-UPS connected to utility power for 16 hours while the battery charges to full capacity.

As a battery ages, the runtime capability decreases. Contact APC at the Web site www. The Building Wiring Fault LED illuminates The building wiring presents a shock hazard that must be corrected by a qualified electrical.

Do not operate the Back-UPS. Call a qualified electrician to correct the building wiring fault. The internet connection is lost during a power outage. Verify that the data line from the wall outlet is connected to appropriate port on the Back-UPS.

PADI OWD PDF

APC BackUPS ES Series BE350G (APC ES 350) 12V 3.2Ah UPS Replacement Battery

.

BREITFELD & SCHLIEKERT PDF

APC BACK-UPS ES BE350G Battery Replacement

.

Related Articles